Table of Contents
Advertisement
The info page displays the information and status of this projector.
For more information, visit
Shutting down the projector
1. Press
on the projector or
control and a confirmation message will appear
prompting you. If you don't respond in a few
seconds, the message will disappear.
2. Press
or
indicator flashes orange, the projection light source
shuts down, and the fans will continue to run for
approximately 90 seconds to cool down the
projector.
3. Once the cooling process finishes, the power indicator becomes a steady orange and fans
stop. Disconnect the power cord from the power outlet.
• To protect the light source, the projector will not respond to any commands during the cooling process.
• Avoid turning on the projector immediately after turning it off as excessive heat may shorten light source life.
• Light source life results will vary depending on environmental conditions and usage.
Direct power off
The AC power cord can be pulled out right after the projector is turned off. To protect the light
source, wait about 10 minutes before re-starting the projector. If you attempt to re-start the
projector, the fans may run for a few minutes to cool down. In such cases, press
to start the projector after the fans stop and the power indicator turns orange.
28
Operation
http://www.crestron.com
on the remote
a second time. The power
Press Exit to go back to the remote
network operation page.
& www.crestron.com/getroomview.
or
again
Advertisement
Table of Contents
