Table of Contents
Advertisement
Available languages
Available languages
Note! When fi rst fi lled or after running dry, it can take up to
45 seconds for steam to be produced.
It takes a few seconds for steam to enter the cleaning pad.
The steam mop will now glide easily over the surface to be
sanitized/cleaned.
Push and pull the steam mop slowly across the surface to
thoroughly steam clean each section.
When you have fi nished using the steam mop, return
the handle (9) to the upright position, making sure that it
is supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately fi ve minutes).
Caution! It is important to monitor the water level in the water
tank (4). To refi ll the water tank and continue to sanitize/
clean stand the mop upright making sure that the handle is
supported and turn the steam mop 'OFF'. Unplug the unit from
the electrical wall outlet, refi ll the water tank (4).
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (9) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
After use (Fig. H)
Turn the steam mop 'OFF'. turn the steam operation
button (2) to off and then press the ON/OFF button (1).
Wait until the steam mop cools down.
Unplug the steam mop from the electrical wall outlet.
Empty the water tank.
remove the cleaning pad (7) and wash it ready for next
use.
Wrap the power supply cable around the tidy hook (10).
Technical Data
Voltage
V
ac
Power
W
Tank
ml
Capacity
Weight
kg
FSMH13E5
FSMH13E10
230
230
1300
1300
380
380
1,8
1,8
(Original instructions)
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Problem
Step
The steam
1.
mop is not
turning on
2.
3.
The steam
4.
mop is not
producing
steam
5.
6.
Where can
7.
I get further
information/
accessories
for my steam
mop
ENGLISH
Possible solution
Check the unit is plugged in at
the wall
socket.
Check the unit is switched on
using the ON/OFF switch (1)
Check the fuse in the plug.
Check the water tank (4) is full
.
NOTE: When fi rst fi lled or after
running dry it can take up to
45 seconds for steam to be
produced.
Check the steam generation
button is in the ON position
(2).
The steamer is equipped with
a thermostat and a thermal
cut-out. If for any reason the
steamer overheats it will switch
off. If this happens turn off and
unplug the steamer, allow to cool
for 2 to 4 hours and re-try.
Refer to the assembly chapter of
the manual for correct fi tting of
parts and accessories.
7
Advertisement
Table of Contents
