Table of Contents
Advertisement
If
icon is displayed:
icon indicates that the wireless router and the printer are not connected. Check the network settings of the
printer. Also, revisit the location of the wireless router and printer at the next check.
For Wired LAN
1.
1. Check the power and LAN cable.
When the printer cannot be found on the setup screen, using LAN connection setup, make sure that
all the network devices are connected to the router and the hub via LAN cables and that all the
devices are turned on.
• If LAN cable is not connected:
•
Connect the router, hub, computer and printer via LAN cables.
Make sure the printer is turned on.
Power Supply
Make sure the printer, the router and the hub are turned on.
• If LAN cable is connected, and printer and network device are off:
•
Turn on printer and network device.
• If LAN cable is connected, and printer and network device are on:
•
Turn them off and on again.
Note
•
• Some devices require a couple of minutes after being turned on to become ready for use.
Wait until all devices are ready before proceeding.
2. Check printer's wired LAN settings.
2.
Make sure
•
• If icon is not displayed:
The printer is not set to use wired communication. Enable Wired LAN from the printer settings.
From the Setup menu screen, select Device settings > LAN settings > Wired LAN > Enab./
dis. wired LAN in this order and select Enable.
Check location of wireless router.
Check4
Make sure the printer is not placed too far away from the wireless router.
The printer can be up 50 m (164 ft.) from the wireless router indoors if unobstructed. Make sure the printer is
close enough to the wireless router to be used.
Place the printer and wireless router where there are no obstacles between them. Wireless communication
between different rooms or floors is generally poor. Wireless communication can be impeded by building
materials containing metal or concrete. If the printer cannot communicate with the computer over a Wi-Fi due
to a wall, place the printer and the computer in the same room.
icon is displayed on the LCD when Setup button is pressed once or twice.
290
Advertisement
Table of Contents
