Christie LX66A User Manual page 69

Some displays are not seen
during the Operation.
Only part of image is displayed.
(Large/Small)
PIN code dialog box appears at start-up. – PJ PIN code lock is being set. Input a PIN code (1234 or numbers you have
Image is not displayed on the
monitor connected to the ANALOG
OUT terminal.
The Top Control does not work.
The Wireless Remote Control
does not work.
USB mouse does not operate properly. – Check cable connection of the USB mouse and the projector. (
SHUTTER button does not operate.
Lens position moves when Input
is switched.
Some operating menu items do not appear. – Check the My menu setting. (
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
You can often correct operating problems yourself. If a projector fails to work properly, see "TROUBLESHOOTING" section
on page 68, 69. To correct failure, try "Solutions".
If after following all operating instructions, you find that service is necessary, contact Christie Service Station or store where
you purchased unit. Give model number and explain difficulty. We will advise you how to obtain service.
– Check the Display item. (
– Check if you are in D. Zoom+/– mode. (
– Change Aspect setting in the Screen setting menu. (
– Adjust Display area and Position in the PC adjust menu. (
set). ( "Enter a PJ PIN Code" on pages 27 and 55)
– Select Input 1 with the Input button on the top control or the INPUT 1 button
on the remote control, or through the Input Menu. (
– Make sure Analog out is "On." (
– Check if the Keylock function is set. (
– Check the batteries. When replacing, the two batteries should be replaced
at the same time. ( page 17)
– Make sure no obstruction is between the projector and remote control.
– Make sure you are not too far from the projector when using the remote
control. Maximum operating range is 32.8' (10m).
– Make sure the ID and CH of the remote control is conformed to the
projector. ( p. 16, 51)
– Initialize the remote control ID and CH, and then initialize the remote control
ID and CH of the projector as well. (
– Unlock Key lock for the remote control in the Setting Menu. (
– Make sure the wired remote cable is not connected to the projector.
( p. 25)
When all the solutions above fail, try Factory default in the Setting menu.
( p. 56)
– Make sure Shutter protection is "Off." (
– Check Lens memory for each input. (
"Setting" on page 52)
p. 32, 48)
p. 47)
p. 30, 36)
"Setting" on page 53)
"Setting" on page 54)
p. 16, 51)
"Setting" on page 53)
"Setting" on page 53)
"Setting" on page 49)
Appendix
p. 41–42)
p. 54)
p. 25)
69