Freemotion GZPL40210 Owner's Manual page 7

MAINTENANCE
It is important for safe and trouble-free operation of your FreeMotion Fitness
routine preventative maintenance on a regular basis. Make sure all parts are properly tightened each time the
strength machine is used. Replace any worn parts immediately. The strength machine can be cleaned with a
damp cloth and a mild, non-abrasive detergent. Do not use solvents.
Note: Instruct all personnel to perform equipment inspection and maintenance requirements. Personnel must
record and report any accident. Contact FreeMotion Fitness Customer Service at 1-800-201-2109 with any
questions or concerns.
Use only original FreeMotion Fitness parts for repair or replacement to maintain your machine's warranty.
FreeMotion recommends the following procedures:
SCHEDULED MAINTENANCE
DAILY
1. Upholstery—General cleaning:
• Wipe using a soft cloth dampened with a light
solution of household dish detergent and warm
water.
• If necessary, use a soft bristle brush with the
solution.
• Always remove the cleaning solution using a
cloth dampened with clean water. Rinse often.
2. Upholstery—Difficult stains:
• Spray the stain with a nonabrasive household
cleanser such as FORMULA 409
®,
GREEN or a similar product.
• Rub the area gently and let it set for a few min-
utes.
• Rinse thoroughly using a clean, water-damp-
ened cloth.
• Repeat if necessary using a soft bristle brush.
Optional method for difficult stains
• Rub the area gently using a soft cloth damp-
ened with rubbing alcohol.
• Rinse thoroughly using a water-dampened
cloth to remove alcohol residue with .
CAUTION: When using any cleaning product, try
it first in an inconspicuous place to ensure there
is no damage to the material. Follow directions
and adhere to safety precautions of each manu-
facturer of cleaning agent used. FreeMotion
Fitness and its vendors cannot be held liable for
damage or injuries resulting from the use or mis-
use of cleaning products.
3. Frames:
• Wipe with a light solution of mild soap and warm
Important: Do not use abrasive cleaners
because they may scratch the equipment. Strong
cleansers and abrasives will damage decals. Use
caution around decals. Do not use solvents such
as lacquer thinner, kerosene, gasoline or similar
liquids.
®
, SIMPLE 4. Stainless Steel Covers:
• Wipe with a light solution of mild soap and warm
• If desired, or to remove corrosion, use available
5. Handles:
• Check all handle straps for wear.
• Visually check each strap along the full length
• A "fuzz" on the strap will appear over time and is
6. Straps with Rings:
• If a ring is pulling through the strap or tearing
• Check stitching points on straps for tears, worn
7
® strength equipment to perform
water. Rinse and dry thoroughly.
water. Rinse and dry thoroughly.
commercial stainless steel polishing com-
pounds. Follow manufacturer's instructions.
for signs of wear such as cuts, tears or nicks.
Replace immediately if required.
not a concern unless it appears to be worn
through strands of the weave.
away from the edge of the strap, replace the
strap immediately.
spots or separation. Replace if necessary as
required.