Using The On-Screen Display (Osd) Controls - Lenovo Q24i-20 User Manual

Using the On-Screen Display (OSD) controls

To adjust the settings, the user controls can be viewed through the OSD�
Q24i-20
Basic Settings
Imae Settings
Port Settings
Menu Settings
Input Signal:HDMI
To use the controls:
1� Press to open the main OSD menu�
2� Use or
function� If there is a sub-menu, you can move between options using
to select that function� Use
3� Press to move backwards through the sub-menus and exit from the OSD�
4� Press and hold > for 10 seconds to lock the OSD� This will prevent accidental adjustments to
the OSD� Press and hold > for 10 seconds to unlock the OSD and allow adjustments to the
OSD�
5� Enables DDC/CI by default� Use
enable DDC/CI function� A message "DDC/CI disable" is shown on the screen�
Brightness 75
Contrast 75
DCR Off
Display Mode Standard
Scaling Mode Full Screen
Speaker 50
Resolution : 1920x1080
to move among the icons� Select an icon and press
or to make adjustments then press
Refresh rate num : 60Hz
Key, Press and hold
/> to access the selected
or , then press
to save�
for 10 seconds to disable/
Chapter 2. 2-4
/>