Graco LDM5 Instructions Manual page 12

Meter Setup and Operation Instructions
3. Squeeze the trigger.
Fluid begins to flow, and the amount shown on the
display counts up from zero.
$872
0D[LPXP :RUNLQJ 3UHVVXUH  EDU  36,
F . 16
IG
4. Release the trigger when you have dispensed the
desired amount of fluid.
Fluid flow stops, and the amount you have dis-
pensed is shown on the display (F
NOTE: When you release the trigger, the nozzle should
prevent fluid from running out of the extension. If fluid
does run out, see Replacing the Nozzle on page 18.
Viewing Totals
This is the procedure for viewing the non-resettable and
resettable totals in gallons or liters. To change the reset-
table total, see Resettable Total, page 9.
1. If display is blank (in sleep
mode), press and hold either
the Total or Rest button.
12
376 476
*$/
/,7(56
5727$/
ti12043a
. 16).
IG
$872
0D[LPXP :RUNLQJ 3UHVVXUH  EDU  36,
F . 17
IG
2. Press and hold Total button.
The resettable total amount is
displayed (F . 17).
IG
If the unit of measurement is gallons, quarts, or
pints, the resettable total is displayed in gallons,
(F . 17). If the unit of measurement is liters, the
IG
resettable total is displayed in liters.
$872
0D[LPXP :RUNLQJ 3UHVVXUH  EDU  36,
F . 18
IG
376 476
*$/
/,7(56
5727$/
ti12049a
376 476
*$/
/,7(56
5727$/
ti12050a
3A1451C