Pioneer PDP-503CMX Service Manual page 92

PDP-503CMX, PDP-503MXE, PDA-5002
1 5 10
1
I N I T
5
P U L S
10
15
16
8. FINAL SET UP: Setting to the factory shipping state.
(Refer to the Final Setup Details.)
9. VIDEO STANDARD: Set the peak occurrences of STANDARD (USER MENU / POWER CONTROL) in the video system signal.
(Set the following table 1.) Note: Please do not perform the change of setting in the service.
10. PC STANDARD: Set the peak occurrences of STANDARD (USER MENU / POWER CONTROL) in the PC system signal.
(Set the following table 2.) Note: Please do not perform the change of setting in the service.
11. VIDEO MODE1: Set the peak occurrences of MODE1 (USER MENU / POWER CONTROL) in the video system signal.
(Set the following table 3.) Note: Please do not perform the change of setting in the service.
12. PC MODE1: Set the peak occurrences of MODE1 (USER MENU / POWER CONTROL) in the PC system signal.
(Set the following table 4.) Note: Please do not perform the change of setting in the service.
STANDARD mode
POWER CONTROL
MODE1
setting
MODE2
13. EEP DATA READ: Display the each address data of EEPROM.
1 5 10
1
I N I T
5
10
E E P D A T A
15
16
14. MASK1: Select the full mask. (Refer to "1 MASK1" .)
Note: Mask 1/2 are commonness and perform one item last memory.
15. MASK2: Select the mask pattern. (Refer to "2 MASK2" .)
Note: Mask 1/2 are commonness and perform one item last memory.
Caution: (item 14, 15 commonness)
• When key operation is done and performs OSD display, turns OFF FULL MASK for two seconds and display OSD. (common to in all modes)
• In FULL MASK selection (in MASK selection menu), Select the mask and turn off OSD two seconds later of no operation, and MASK screen
displays.
• Perform MASK determination (press "SET"), and FULL MASK screen display starts.
• Release of the mask is possible only with "M00" with the RS-232C factory adjustment mode or "MASK OFF" of the service factory menu.
(Release is impossible with "FULL MASK OFF" of the integrator menu and "FMN" of the RS-232C command.)
92
15 20 25 30
# 1 – S 1 – I N 4 – 0 2 –
E M E T E R S E T ?
Y E S N O
Current Input Signal
VIDEO
Table1
Table3
PL6 (fixed)
15 20 25 30
# 1 – S 1 – I N 4 – 0 2 –
R E A D : 1 0 F F - 8
35 40
: YES/NO selection
∗
2 N T
SET : Store the SET DATA at YES selection
and shift to INIT screen.
Hold the NOW DATA at NO selection
and shift to INIT screen.
PC
Table2
Table4
35 40
: Select the address (four places) place.
∗
2 N T
5∞ : Select numeric value.
SET : Shift to upper layer.
Update display data (hex) every address modification.
Display color : White (Selected address is yellow)
Half tone
0
: Blue (second row / 15th row for
each 5 to 36th columns)