Pioneer PDP-503CMX Service Manual page 175

CONNECTION PANEL
8Ω ~16Ω
R
SPEAKER
+ –
1
Plasma Display [PDP-503CMX/PDP-503MXE]
Section
The plasma display is provided with 2 video input
connectors, 1 video output connector, audio input/output
jacks and speaker terminals.
There are also CONTROL IN/OUT jacks for connection of
PIONEER components with the Î mark.
When this video card is installed on a plasma display, an
additional three sets of video input connectors are provided
(total five), together with one additional video output
connector (total two).
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16 Ω.
2
CONTROL IN/OUT (monaural mini jacks)
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables control
of the plasma display as a component in a system.
3
COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE
TERMINALS.
These terminals are used in the factory setup.
PDP-503CMX, PDP-503MXE, PDA-5002
OFF
INPUT5 AUDIO INPUT3 S-VIDEO
R L
DIGITAL RGB
! @ # $
CONTROL COMBINATION RS-232C
IN OUT
IN OUT
2 3 4
AC INLET
ON
- =
AUDIO INPUT4 VIDEO OUTPUT
R L
% ^
INPUT1 (ON SYNC)
OUTPUT
G B
ANALOG RGB (ANALOG RGB)
5 6
4
RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
5
INPUT1 (mini D-sub 15 pin)
For connection of components that have RGB or
component output jacks such as a personal computer,
DVD player, or external RGB decoder. Make sure that
the connection made corresponds to the format of the
signal output from the connected component.
6
OUTPUT (INPUT1) (mini D-sub 15 pin)
Use the OUTPUT (INPUT1) connector to output the
video signal to an external monitor or other component.
Note: The video signal will not be output from the
OUTPUT (INPUT1) connector when the main power of
this display is off or in standby mode.
7
INPUT2 (BNC jacks)
For connection of components that have RGB or
component output jacks such as a personal computer,
DVD player, or external RGB decoder. Make sure that
the connection made corresponds to the format of the
signal output from the connected component.
8Ω ~16Ω L
SPEAKER
+ –
~
INPUT2 (H/V SYNC) AUDIO
R HD VD
INPUT OUTPUT
(INPUT1/2)
75 2.2
Ô
Ω
kΩ
7 89 0
175