Panasonic CF-T5 Service Manual page 58

9.3.4.4. Assembly of the LCD Knob
Rib match
(Gap 0.5mm or less)
Difference match
(Gap 0.5mm or less)
LCD Knob
The hook is inserted while doing the slide.
9.3.4.5. Assembly of the Touch Pad
Affixation of PAD Cover Tape
Insertion of FFC(PAD)
FFC(PAD)
FFC (PAD)
ed in the connector
in the direction
where the reinforce-
ment board is seen.
Touch PAD
Affixation of PAD Sheet
Two sided tape
0 1mm
Sets in the dent.
Put on the case before
Sheet
inserting the knob
KNOB and SRING
are fixed
It is a thing which does not run
PAD Cover
PAD
aground in the pin as for the
Cover Tape
PAD button seat.
Tape
Installation of PAD button
is insert-
Hook is inserted in a top case.(4 places)
Affixation of Touch PAD
This line must
become vertical.
PAD Sheet
After PAD Sheet
is affixed, the flak-
ing off paper is
peeled off.
Confirm the LCD knob operates after installing the spring.
Spring
The spring is hung.
The spring installation part opening
edge is matched and put between
positional decision pins.
Affixation of PAD Sheet
To install on
the ditch, the
gasket is put.
Inserts in the
positioning
pin.
PAD Button
Sets in the dent.
Pin for
positioning
The Touch PAD
is put
Touch PAD
58
This line must
become vertical.
PAD Sheet
After PAD Sheet
is affixed, the flak-
ing off paper is
peeled off.
Affixation of PAD Cover
Hook
It is confirmed that
all LED lenses fit
in the hole of the
PAD cover.
PAD Cover
Insert Hooks