Maintenance And Troubleshooting - BorMann Pro BBP2200 Manual

EN
Select a low level for small screws or soft materials.
Select a high level for large screws, hard materials or removing screws.
Select the drill setting for drilling work by adjusting the torque selection right to the drilling position.
Push the speed selector to the rear for drilling work (position 2).
Set the torque selector ring to the hammer function setting indicated by an hammer icon in order to drill through walls.
Changing direction of rotation/unlock appliance
Unlock the appliance and change the direction of rotation by pressing the Forward/Reverse switch towards the left or right.
Switching on and off
Switching on: To start the appliance, press the ON/OFF switch and keep it pressed in.
Switching off: Release the appliance's ON/OFF switch to switch off the appliance.
Charging batteries
Warning: Use only the original charger to charge the batteries supplied by the manufacturer. Only batteries and chargers designed by Bormann can be used in
conjunction with this product.
The use of any other types of batteries / chargers in combination with this product is considered abuse and will void the warranty.
Once connected to the power supply, the battery can be recharged without the need for monitoring. The complex construction of the circuit monitors the
condition of the battery by adjusting the recharge current to match the requirements. When the recharge cycle is complete and to maintain full capacity, a
low-voltage output current will continue to be powered as needed.
Warning!
• Check the status of the charger and battery before each charge. If there is any indication of a fault then do not continue, seek advice from an authorized
vendor.
Battery pack efficiency and charging advice
Recharge the battery packs before they become completely exhausted
When you feel that the power of the tool becomes weaker, stop using the tool and recharge the battery packs. If you continue to use the tool and exhaust the
electric current, the battery pack may become damaged.
Avoid recharging at high temperatures. A rechargeable battery pack will be hot immediately after use. If such a battery pack is recharged immediately after
use, its internal chemical substance will deteriorate, and the battery life will be shortened. Leave the battery pack and recharge it after it has cooled for a while.
The battery pack should only be used and/or charged when battery pack temperature is between 50C and 300C.
The battery pack needs to be warmed-up or cooled down in order to prevent damage to the batteries internal components.
Note: Failure to warm up or cool down a battery pack could result in serious damage to tie battery, charger and user.

Maintenance and Troubleshooting

Maintenance
Regular inspection and cleaning reduces the necessity for maintenance operations and will keep your tool in good working condition. The motor must be
correctly ventilated during tool operation. Avoid blocking the air inlets and vacuum the ventilation slots regularly.
WARNING: Always remove the rechargeable battery from the device before all work.
• Replace all damaged or worn parts to ensure the power tool is always ready for safe operation.
• Clean ventilation slots and openings with a brush.
• DO NOT use any solvents or cleaning agents containing chemicals which could damage the plastic parts. Wipe the housing clean with a cloth.
• Always store the leaf blower in a dry, frost-free location beyond the reach of children.
• Store and charge your rechargeable batteries at a cool location. Temperatures above or below normal room temperature shorten the lifespan of the recharge-
able batteries.
• Do not store rechargeable batteries when discharged. Wait until the rechargeable battery has cooled down and charge it completely.
• Rechargeable batteries gradually lose their charge. The higher the temperature, the quicker they lose their charge. For longer storage periods, recharge the
rechargeable battery every one or two months. This will extend the lifespan of the rechargeable battery.
4
WWW.BORMANNTOOLS.COM