Inserting The Batteries; Operating Range - Panasonic PT-L780U Operating Instructions Manual

Inserting the batteries

# Open the cover.
$ Insert the batteries so that the
polarities are correct, and then close the
cover.
AAA batteries
(two)
NOTE:
B Do not drop the remote control unit.
B Do not drop the remote control unit.
B Keep the remote control unit away from liquids.
B Keep the remote control unit away from liquids.
B Remove the batteries if not using the remote control unit for long periods.
B Remove the batteries if not using the remote control unit for long periods.
B Do not use rechargeable batteries.
B Do not use rechargeable batteries.

Operating range

If the remote control unit is held so
that it is facing directly in front of the
remote control signal receptors on
the front or rear of the projector, the
operating range is within
approximately 7 m (23´) from the
surfaces of the receptors.
Furthermore, the remote control unit
can be operated from an angle of
±30° to the left or right and ±15°
above or below the receptors.
20
All manuals and user guides at all-guides.com
NOTE:
B If there are any obstacles in between B If there are any obstacles in between
the remote control unit and the the remote control unit and the
receivers, the remote control unit may receivers, the remote control unit may
not operate correctly. not operate correctly.
B If strong light is allowed to shine onto B If strong light is allowed to shine onto
the remote control signal receiver, the remote control signal receiver,
correct remote control operation may correct remote control operation may
not be possible. Place the projector as not be possible. Place the projector as
far away from light sources as possible. far away from light sources as possible.
B If facing the remote control unit B If facing the remote control unit
toward the screen to operate the toward the screen to operate the
projector, the operating range of the projector, the operating range of the
remote control unit will be limited by remote control unit will be limited by
the amount of light reflection loss the amount of light reflection loss
caused by the characteristics of the caused by the characteristics of the
screen used. screen used.
Setting the proj
remote control
When controlling multiple proje
single remote control unit, proj
unit as described in the followi
#Press the ID SET button o
ID number "ALL" will be disp
$Press and hold the ID SET
The ID number will change
through ID numbers "2", "3"
pressed.
%Select the ID number you
When the projector ID coinc
<If the MAIN POWER is ON>
The ID number will be displaye
If the projector ID and ID for th
projector ID is displayed in gre
<If the projector is in standby m
The Power indicator on the pro
If the projector ID and ID for th
Power indicator will stay illumi
NOTE:
B The projector ID number in
default. It is therefore not ne
only one projector is used.
B The projector can be turned
the projector ID is set in the
projector ID setting, see pag