Figure 9. Configuration Tool (Option Config.) - Wiznet WIZ1000-EU User Manual

2.2.3. Option configuration
ⓣ
Inactivity timer
After the connection is established, if there is not data transmission within the time defined
in Inactivity time, the connection is closed automatically.
The default value is '0'. If '0' is set, this function is not activated. In this default setting, the
connection is maintained even though there is no data transmission. In order to close the
connection, the 'Close' command should be given.
This function can be used for more than two or more systems to connect to a WIZ1000 module.
If one system holds the connection to the WIZ1000, other systems cannot connect to the
module. If there is no data transmission during the time defined in Inactivity time, the
connection will be closed for other system to be connected.
Copyright © WIZnet All Rights Reserved

Figure 9. Configuration Tool (Option Config.)

ⓣ
ⓤ
ⓥ
ⓦ
ⓧ
ⓨ
WIZ1000 | 20 page