Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor Password
item on top of the screen shows the default Not Installed. After you set a password,
this item shows Installed.
To set a Supervisor Password:
1. Select the Change Supervisor Password item and press <Enter>.
2. From the password box, type a password composed of at least six letters and/or
numbers then press <Enter>.
3. Confirm the password when prompted.
The message "Password Installed" appears after you successfully set your
password.
To change the supervisor password, follow the same steps as in setting a user
password.
To clear the supervisor password, select the Change Supervisor Password then
press <Enter>. The message "Password Uninstalled" appears.
Note:
If you forget your BIOS password, you can clear it by erasing the CMOS Real
Time Clock (RTC) RAM.
After you have set a supervisor password, the other items appear to allow you to
change other security settings.
Figure 59: Security Settings Sub-menu
User Access Level (Full Access)
This item allows you to select the access restriction to the Setup items. Configuration
options:
[No Access] [View Only] [Limited] [Full Access]
75
Vig565s Motherboard Manual