Before First Use; Installing Your Oven Accessories - Westinghouse WVES613 User Manual

BEFORE FIRST USE

Preparing your appliance for the first time
• Please remove all internal boxes and bags from the
oven before operation.
• Please wipe out the oven interior prior to operation
with warm soapy water and polish dry with a soft
clean cloth. Do not close the oven door until the oven
is completely dry.
• If your appliance is fitted with a mechanical "Auto
Off" timer, make sure it is set to "Off" marker for
manual operation.
WARNING CAUTION
• Do not line the oven with foil as it will damage the
enamel.
• New appliances can have an odour during first use. It
is recommended to 'run in' the oven before cooking
for the first time. Operate the oven(s), empty, at a
temperature of 180°C for approximately 30 minutes.
For appliances with a separate grill, run the grill on
maximum for 15 minutes WITH GRILL DOOR OPEN.
Please ensure that the room is well ventilated during
this process.
Setting the time of day
If you have purchased a model fitted with an electronic
clock or programmable controller, you must set the time
of day before you can operate your appliance.
Electronic clock
• After the appliance has been electrically connected,
"12.00" will be displayed and the "Clock" indicator
symbol will flash.
• To set the time of day, press the or symbols.
• After 5 seconds from the last change, the "Clock"
indicator symbol will disappear, confirming the
time has been set.
NOTE: The clock has a 24 hour display.
14
BEFORE FIRST USE
WVEP615, WVEP627, WVEP617 controller
Before the appliance can be used, the time must be set.
When power is supplied to the oven, the clock icon will be
displayed. Along with the clock symbol the "12" will be
flashing. This indicated that the "hour" portion of the time
is ready to be changed.
Toggle the temperature selector or , then touch
when you have the right hour.
The minutes will flash and can be set in the same manner.
5 seconds after the last change, the clock display will stop
flashing, confirming that the time has been set.
NOTE: The clock has a 24 hour display.
WVEP618 programmable controller
• After the appliance has been electrically connected,
press to turn ON
• To set the time, press until "Settings" is highlighted
and press OK
• Then, "Set time of day" is highlighted and press
• Press or to set the hour and press
• Press or to set the minutes and press
• Press to return to function menu

INSTALLING YOUR OVEN ACCESSORIES

Slides (Telescopic runners)
(For applicable models only)
1. Obtain left hand side rack and left hand slide – see
image to identify.
2. The shaded wires indicate the wire the slide can be
mounted on. Fit slide rear clips to the rear of wire at
an angle as shown below.
1
1
2
2
1
2
3
3. Push slide front clip over wire until secured
CLICK !
3
CLICK !
3
CLICK !
Side racks
• The side racks attach to each side of your oven.
There is a left hand and right hand version (see image
below for details).
• Insert the rear peg into the rear access hole provided,
ensuring that the peg is fully inserted.
• Then locate the front peg into the front access hole
and push in firmly.
• For the grill compartments on WVE626, WVE665,
and WVEP627 models, the side rack fitment is the
same as above.
Front Peg Rear Peg
Left hand side rack
Shelves and trays
The shelves are designed so that they have maximum
extension but cannot be accidentally pulled right out.
To fit a shelf to side racks:
NOTE: To Locate the rear edge of the shelves, the detents
on the side wires should be towards the oven back wall.
See image.
1. Rest the rear edge of the shelf on the lower guide rail
of the side rack - see diagram. Ensure the same rail
positions on both sides of the oven are being engaged.
2. With the front edge raised, begin to slide the shelf in
between the guide rails of the side rack.
3. Once the detents have passed the front edge of the
side rack, the shelf can be pushed fully in.
Detent
4. When fully inserted the shelf should not interfere with
the closed oven door.
INSTALLING YOUR OVEN ACCESSORIES
15