Notes - Westinghouse WVES613 User Manual

TROUBLESHOOTING (CONTINUED)
Oven
PROBLEM POSSIBLE CAUSE
Oven or grill • Time of day not set.
not working
• Power not turned on.
• Controls are incorrectly set.
• Oven is in 'Demo' mode, refer to Using your oven section.
• Household fuse has blown or power supply is off.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
• Child-proof oven lock is activated. 'LOCKED' is displayed when control is
touched. (Refer to Using your oven section)
The oven seal is loose • The oven seal is only attached at each corner. It may seem like a loose fit but
when the oven door is closed it will function correctly.
Oven light • Light may be turned off at control panel.
not working
• Lamp blown or loose in socket.
• Household fuse has blown.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
Oven not heating enough • Foil or trays on bottom of oven.
• Timer is in "AUTO" mode. (Refer to timer operating instructions)
• Household fuse has blown.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
• Oven not pre-heated. Pre-heat oven for 30 minutes.
Clock flashing • Reset time of day and any cooking functions you were using.
on display
Unit smoking • Protective oils being removed.
when first used
Condensation • Reduce the amount of water used in cooking. (Sometimes condensation is
build up normal)
Door cannot be replaced • Stirrup not engaged properly.
after removal
Functions and temperature • Oven is in 'Demo' mode, refer to Using your oven section.
appear on display but oven does
not work
When the door is open the fan • This is a function of the power board to help reduce the blast of air when
stops (underbench only) opening the door.
When a non fan mode is selected • Most oven modes have a fast heat up function that uses the fan, fan element
the fan starts and top (boost) elements. Auto fast heat up can be overridden by selecting a
temperature of 120°C or less, allowing the function to start, then increasing the
temperature to the desired level.
The light stays on when the door • An oven function has been selected.
is closed
• The light has been turned on at the control panel.
The light does not turn *ON* • Oven light may need replacing.
when the door is opened
Shelf or telescopic runner slides Oven cavity is not level, you can perform a check using a level to verify this
out when door is opened (refer to installation section). If not level refer to installer.
NOTE: Only authorised personnel should carry out servicing.
52
TROUBLESHOOTING

NOTES

53
NOTES