Help with minor problems
Fault displays
Text in display field
and signal emitted
F:16
F:17
F:18
49
If repairs are needed, and assuming that you cannot
eliminate the fault yourself with the aid the following
table:
■
■
■
■
m
Repairs may be carried out by customer service or
authorised technicians only.
Possible cause
Door not closed properly.
Tap not turned on.
Inlet hose kinked or pinched.
Filter blocked in water inlet hose. Clean filter, see page 47.
Water pressure too low.
Loose debris is blocking the pump. Clean the pump, see page 45.
Drainage pipe and/or drainage
hose blocked.
There is too much residual water in
the drum when drying.
Turn the programme selector to Off.
Disconnect the appliance from the mains.
Turn off the tap.
Call customer service, see page 54.
Risk of electric shock!
Remedial action
Check whether laundry is trapped in door;
Close the washer-dryer door.
Turn the tap on.
Eliminate cause.
Eliminate cause.
Clean drainage pipe and/or drainage hose.
Stop the drying programme, select the " Spin Í "
programme before drying.