Box Contents - Axial AXI00005T1 Instruction Manual

EN
WET CONDITIONS MAINTENANCE
• Drain any water that has collected in the tires by spinning them at high speed. With the body removed, place the
vehicle upside down and pull full throttle for a few short bursts until the water has been removed.
CAUTION: Always keep hands, fingers, tools and any loose or hanging objects away from rotating parts
when performing the above drying technique.
• Remove the battery pack(s) and dry the contacts. If you have an air compressor or a can of compressed air, blow out
any water that may be inside the recessed connector housing.
• Remove the tires/wheels from the vehicle and gently rinse the mud and dirt off with a garden hose. Avoid rinsing the
bearings and transmission.
NOTICE: Never use a pressure washer to clean your vehicle.
• Use an air compressor or a can of compressed air to dry the vehicle and help remove any water that may have gotten
into small crevices or corners.
• Spray the bearings, drive train, fasteners and other metal parts with a water-displacing light oil. Do not spray the motor.
• Let the vehicle air dry before you store it. Water (and oil) may continue to drip for a few hours.
• Increase the frequency of disassembly, inspection and lubrication of the following:
• Front and rear axle hub assembly bearings.
• All transmission cases, gears and differentials.
• Motor—clean with an aerosol motor cleaner and re-oil the bushings with lightweight motor oil.

BOX CONTENTS

Vehicle
Transmitter
Charger
Vehicle Battery
Motor
ESC/Receiver
Servo
Transmitter Batteries (4) AA Alkaline
INCLUDED COMPONENTS
SCX Jeep Gladiator 1/24th Scale RTR (AXI00005)
2.4 GHz 4 channel (HRZ00014)
USB LiPo Charger (DYNC1063)
7.4V, 350mAh, 2S LiPo (DYNB0012)
SCX24 030-Motor with Pinion (DYNS1217)
ESC/Rx with Forward and Reverse (HRZ00015)
AS-1 Micro Servo (AXI31619)
Length
Width
Height
Operating Weight 9.45 oz (268g)
4
SPECIFICATIONS
9.6" (244mm)
3.9" (100mm)
4.4" (111mm)