Seamless Loop/Hot Start/Stutter/Trim - Denon DN-HC5000E2 Full Manual

4. Seamless Loop/Hot Start/Stutter/Trim

Operation display
(refer to the section describing the display)
q, w, y r
e t, y
1. Setting the A point
(loading the Hot Start data)
q Press the A1 or A2 button to
set the A point and Hot Start
data loading starts.
• A1 and A2 buttons can be
used separately for each
Hot Start.
• When an A point is set, the corresponding A
button and " " display light and that button
is set to the Hot Start mode.
2. Starts Hot Start
w When A1 or A2 button
is pressed, Hot Start
playback starts from the
corresponding A point.
3. Setting the B point for Seamless Loop
e When the B button is
pressed after setting the A
point or after starting Hot
start playback, the B point
is set and Seamless Loop
playback starts from the A point.
• T he B button works with respect to the A
point operated before the B button was
pressed.
• I f the B button is pressed during Seamless
Loop playback or after EXIT playback, the B
point moves to the point at which the button
was pressed.
• W hen the B point is set, the B and "
displays light.
4. Playing Seamless Loops
• When the B1 point for A1 is detected after
playback started from A1 point, playback
returns to A1 point with seamless. While A1
to B1 looping, B2 point for A2 ignored.
• When the B2 point for A2 is detected after
playback started from A2 point, playback
returns to A2 point with seamless. While A2
to B2 looping, B1 point for A1 ignored.
5. Exit/Reloop
r In Seamless Loop playback, you can force exit
from or return to the loop.
EXIT:
While the Seamless Loop
playback, press the EXIT/
RELOOP button to exit from
loop. DN-D4000/D4500/
BU4500 continues playback after the B point.
RELOOP:
When the EXIT/RELOOP button is pressed
after exit the loop, Seamless Loop playback
resumes from the A point.
6. Stutter
• A1 and A2 points can
be also used for Stutter
playback.
t To enable stutter playback,
press FLIP button for A1/A2
buttons, then " " display turns off.
Press the FLIP button to switch between the
Hot Start/Seamless Loop and Stutter modes.
7. Clear the A1/A2 point
" y While pressing the FLIP button, press the A1
or A2 button to clear the corresponding A and
B points.
Or press the FLIP button for more than 1 sec
to clear both A1 and A2 points at once.
Quickly pressing the "FLIP" button first and
then A1, A2 or B buttons will clear these
points individually.
23
ENGLISH
ENGLISH
8. Trim
For instructions on the trim function, refer to the
manual of the DN-D4000/D4500/BU4500.
NOTE:
If the setting made at the "CD Mode Sel"
presetting does not correspond to what is actually
connected, the unit may not operate properly.