Installation - Zanussi ZEV6041XBA User Manual

What to do if...
Problem
You cannot activate or operate
the hob.
Residual heat indicator does not
come on.
There is a dark area on the
multiple zone.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob

Installation

WARNING!
Refer to Safety chapters.
Hob and oven connection type
This appliance has a green 1x14 pole
connector and can be connected to an oven
with a green 1x14 pole connector.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
www.zanussi.com
Possible cause
The fuse is blown.
The zone is not hot because it
operated only for a short time.
It is normal that there is a dark
area on the multiple zone.
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The instructions
about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Serial number ...........................
Remedy
7