Black & Decker MM2000R Instruction Manual page 11

4. if the grass collection bag (8) is used
during the fast growing season, the
grass may tend to clog up at the
discharge opening. Release bail handle
to turn mower off and unplug mower.
Remove the catcher and shake the
grass down to the back end of the bag.
Also clean out any grass or debris which
may be packed around the discharge
opening. Replace the grass catcher.
5. if mower should start to vibrate
abnormally, release bail handle to turn
mower off and unplug mower. check
immediately for cause. Vibration is a
warning of trouble. do not operate mower
until a service check has been made.
Refer to troubleshooting guide in manual.
6. ALWAyS RELEASE BAIL hANDLE
TO TURN MOWER OFF AND
UNPLUG MOWER WhEN LEAvING
IT UNATTENDED, EvEN FOR A
ShORT PERIOD OF TIME.
REMOvING AND INSTALLING
BLADE
dANGeR: RISK OF INJURy. When
ReASSembling The blAde SySTem,
enSURe eAch pART iS ReinSTAlled
cORRecTly, AS deScRibed belOW.
impROpeR ASSembly Of The blAde
OR OTheR pARTS Of The blAde
SySTem mAy cAUSe SeRiOUS injURy.
WARNING:
1.
hAndle TO TURn mOWeR Off,
WAiT fOR The blAde TO STOp,
And UnplUg mOWeR.
S
27
T
30
ReleASe bAil
29
28
32
31
2. cut a piece of 2x4 wood (27) (about
2 feet long) (610 mm) to keep blade
from turning while removing nut (28).
3. Wear gloves and proper eye protection.
Turn the mower on its side. be careful
of sharp edges of blade. position wood
and unscrew bolt with 9/16" wrench
(29) as shown in Figure S.
4. note the orientation of each part as
you remove it. Remove nut (30). pull
off washer (31), the blade insulator
(32), the blade (33), the fan (34), and
the spacer (35) as shown in Figure
T. examine all pieces for damage and
replace if necessary.
5. To reassemble, slide the spacer (35)
onto the mower with the wide side
facing out. Slide the fan (34) on with
the blades of the fan facing the mower.
The blade (33) can only be attached
to the fan in one direction. line up the
d-shaped hole of the blade with the
d-shaped post of the fan, ensuring the
writing on the blade faces out away
from the mower. Replace the insulator
(32) so the blade fits in the recess of
the insulator. Replace the washer (31)
with the flat side against the insulator.
Replace the nut (30) with the wide side
against the washer.
6. To tighten firmly, position the piece of
wood as shown in Figure U to keep
the blade from turning. Secure nut
with the wrench.
U
33
11
35
34