Advertisement
Take out all ribs and formers out of their sheets; you can mark the formers with a soft pencil if you like
sand of all holding tabs.
Place main formers on bottom and place doublers; check the drawing for the correct position of the
doublers. Frame up the wing assembly on the sheeting
Mark the main-formers ribs on the bottom sheeting, place main-formers on sheeting place ribs, do not
glue yet, make sure for straightness.
If all seems ok then pin down the main former and start glueing the ribs with thin ca one by one to the
bottom sheeting, note roll the ribs over the sheeting and apply ca
Glue wing assembly to bottom sheeting. Place retract formers in front part of wing (not as shown on
build pictures)
Modellmarkt24.ch
Advertisement
