PEERLESS WSP820 Installation And Assembly

Installation and Assembly:
Metal Stud Wall Plate for FPS-1000 or SP850
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
Parts List
Description
A 20" wall plate
B 1/4-20 x 1/2 phillips head screw
C 1/4" flat washer
D 1/4-20 x 2.5 phillips head screw
E toggler
B
Use a stud finder to locate stud centers. Use wall
plate (A) as a template to mark stud centers
through slots. Drill 3/4" (19 mm) dia. holes through
drywall and studs. Insert togglers (E) as shown
below. Six 1/4-20 x 2.5" phillips screws (D) and six
washers (C) are provided. Place screws (D) through
wall plate (A). Partially fasten the toggler (E) to the
back of the screw. Pivot ends of toggler (E) 90°.
E
C
D
Visit the Peerless Web Site at www.peerlessmounts.com
Qty. Part #
1
4
10 540-9440
6
6
C
D
A
WSP820 WSP820-W
Part #
024-1048 024-2048
510-9108 510-9108
540-9440
520-9522 520-9522
590-1093 590-1093
E
• Make sure that mounting screws are anchored into
the center of the studs. The use of an "edge to edge"
stud finder is highly recommended.
A
C
D
Push toggler (E) through hole.
A
D
A
D
Pull screw (D) back until toggler (E) hits the inside of
the metal stud. Fasten all six screws (D) tight, until
wall plate (A) is flush with wall.
1 of 2
For customer care call 1-800-729-0307 or 708-865-8870.
Model: WSP820,
WSP820-W
A
Maximum Load Capacity: 150 lb (68 kg)
WARNING
E
E
E
ISSUED: 03-24-09 SHEET #: 125-9057-1