Fig. 20: Cleaning The Compressor Casing, Diffuser Mechanically - ABB HT607772 Operation Manual

Operation Manual / TPS44-H.. - TPS52-H..
8 Periodic maintenance work / 8.2 Cleaning components mechanically
8.2.3 Compressor-end, non-rotating parts
WARNING
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or con-
tact with them may be harmful to health.
Do not breathe in these substances and avoid contact with the skin.
u
Ensure proper ventilation.
u
Observe the information in the material safety data sheet for the operat-
u
ing materials and supplies.
Wear personal protective equipment (PPE) according to the material
u
safety data sheet.
Comply with local legislation.
u
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following parts, which are relevant in terms of performance, can be cleaned in accord-
ance with the description below.
Fig. 20: Cleaning the compressor casing, diffuser mechanically
72000 Compressor casing
79000 Diffuser
Steam-clean the above-mentioned components or soak in diesel oil or water with house-
u
hold cleaning agents. After soaking, remove contamination with a brush.
Dry components completely.
u
Spray cleaned surfaces with penetrating oil. Do not spray exterior surfaces of the tur-
u
bocharger.
Dispose of contaminated water and cleaning agents in accordance with the information
u
in the material safety data sheet.
© Copyright 2021 ABB. All rights reserved. HZTL4037_EN Rev.G June 2021