ultracomfort UC559 Owner's Manual page 8

Power lift & recline chair
Table of Contents

Advertisement

M
Models UC214, UC332-M, UC332-L, UC480, UC520, UC536-MLA,
UC542-SMA, UC542-M, UC542-L, UC544-SMA, UC544-MED,
UC544-LAR, UC549-SMA, UC549-MED, UC549-LAR, UC550-JPT,
UC550-M, UC550-L, UC550-M26, UC556-M, UC559-SMA, UC559-MED,
UC559-LAR, UC559-M26, UC790, UC798-MLA
1. Remove AC/DC adapter (transformer) from packaging located under base of
chair. Place two 9 volt alkaline batteries (not included) into the slots provided
as shown. Place transformer on floor behind the chair.
2. Locate the power cord from the motor. It is attached to the motor shaft under
the chair with a white zip tie. Cut white zip tie, extend the cable under and out
behind the chair and connect to the transformer as shown below.
3. Make sure all connections are tight. Plug the adapter wire into a standard
(115-120V A.C.) wall outlet.
Plug
To outlet
115-120V A.C.
You will want to place your chair in the room where it will be most convenient for
you, such as near the television, radio, reading light, end table, or other furniture.
Leave enough space between back of chair and wall or other obstruction to
allow chair to recline (about 18 inches for standard models, 25 inches for Stellar
Comfort models). Recline space needed may vary based on chair model.
Do not allow any objects to restrict movement of the footrest. Some carpets have
a high plush pile that can rub on the bottom of the footrest. This situation can
damage the mechanism. You can correct this situation by turning the levelers
(located under the front of the chair) to raise the footrest enough to clear the
carpet.
Your chair is equipped with a battery back up source. Two 9 volt alkaline batteries
must be installed. Once used, batteries must be replaced. Keep the telephone or
some means of communicating with someone within reach.
P
aking
ower
Y
n
our
L.E.D. light
DC Power
Transformer
C
hair
C
onneCtions
L
C
ew
ift
L.E.D. light
From motor
L
oCation
8
i
n
hair
Bottom view of
Transformer
Install two 9 volt batteries
in transformer for battery
backup (See page 17)
(batteries not included)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents