Table of Contents
Advertisement
Control panel model 2
Control panel
Explanation
Fan on/off
#
Light on/off/dimming
A
-
Reduce the fan settings
+
Increase the fan settings/intensive setting 1, 2
Boost function (short-term maximum power)
&
Fan run-on time
x
Setting the fan
Switching on
Pull out the filter pull-out and press the
fan starts at setting
.
ƒ
Press the + or - button to change the fan strength.
Switching off
Press the
button. Slide the filter pull-out in.
#
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button when the fan is at setting
The intensive setting
2‚
button again activates the intensive setting
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
Boost function
The boost function is a short-term maximum power
setting which can be activated in any fan setting.
Press the
button. After approx. 20 seconds, the fan
&
switches back to the previously set fan setting.
Fan run-on time
Press the
button or slide the filter pull-out in while
x
the extractor hood is operating.
After approx. 10 minutes, the fan switches off
automatically.
Lighting
The lighting can be switched on and off independently
of the fan.
Press the
button.
A
Setting the brightness
Press and hold the
A
button until the desired
brightness is reached.
button. The
#
.
„
is activated. Pressing the +
.
2 ƒ
Saturation display
When the metal grease filters or the activated charcoal
filter are/is saturated, an audible signal will sound for
approximately 4 seconds after the fan is switched off.
In addition, the corresponding symbol will appear on
the display:
!
Metal grease filter:
■
Activated charcoal filter:
■
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced.
For instructions on how to clean the metal grease filters,
please refer to the
"Cleaning and maintenance"
~
on page 8 section.
The saturation indicators can be reset while they are
flashing. To do this, press the – button.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display
must be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Press the
#
and
x
■
the
display for starter sets for circulating-air mode
™"
or
the
display for CleanAir circulating air modules
'"
lights up.
Repeatedly press the button combination to switch
■
the electronic control display back to exhaust air
mode (
display).
!
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
same time for approx. three seconds. An
acknowledgement signal sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Operating the appliance en
"
buttons at the same time until
and + at the
#
7
Advertisement
Table of Contents
