Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Magnum MDP200
Summary of Contents for Magnum MDP200
- Page 1 PORTABLE TRASH PUMPS MDP200 OPERATING & PARTS MANUAL...
-
Page 2: Introduction
Occupational Safety and Health Association (OSHA) guidelines. Keep a copy of this manual with the unit at all times. Additional copies are available from Magnum Products LLC, or can be found at www.m-p-llc.com. An engine operator’s manual was also supplied with the unit at the time of shipment from the factory. -
Page 3: Table Of Contents
TABLE OF CONTENTS Page INTRODUCTION ..........................2 TABLE OF CONTENTS ........................3 SAFETY NOTES ..........................4 OPERATING SAFETY ........................4 ENGINE SAFETY ........................... 5 UNIT SERIAL NUMBER LOCATION ....................6 SAFETY SYMBOL SUMMARY ...................... 6 SPECIFICATIONS .......................... 7 COMPONENT LOCATIONS ......................8 HOSE RECOMMENDATIONS ....................... -
Page 4: Safety Notes
SAFETY NOTES This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. This manual contains DANGERS, WARNINGS, CAUTIONS, NOTICES and NOTES which must be followed to prevent the possibility of improper service, damage to the equipment, personal injury or death. -
Page 5: Engine Safety
ENGINE SAFETY Internal combustion engines present special hazards during operation and fueling! Failure to follow the safety guidelines described below could result in severe injury or death. Read and follow all safety warnings described in the engine operator's manual. A copy of this manual was supplied with unit when it was shipped from the factory. -
Page 6: Unit Serial Number Location
UNIT SERIAL NUMBER LOCATION Refer to the location illustrated below to find the unit ID tag. Important information, such as the unit serial and model numbers are found on this tag. Record the information from this tag, so it is available if the tag is lost or damaged. When ordering parts or requesting technical service information, you may be asked to specify this information. -
Page 7: Specifications
Read all of the manuals included with this unit. Each manual details specific information regarding items such as set-up, use and service requirements. Specifica- tions are subject to change without notice. MAGNUM MODEL MDP200 Pump Output Suction/Discharge Diameter ................2 in. -
Page 8: Component Locations
COMPONENT LOCATIONS FUEL TANK PRIMING PORT RECOIL STARTER AIR FILTER OIL FILL/ LEVEL CHECK DISCHARGE SPARK PLUG SUCTION MUFFLER DRAIN OIL FILL HOSE RECOMMENDATIONS HOSES • Suction hoses must be rigid enough not to collapse when pump is operating. • Discharge hoses need to be thin-walled and collapsible. -
Page 9: Starting The Pump
STARTING THE PUMP Before starting the pump, add engine oil and gasoline. See page 11 for instructions on how to properly fill the unit with engine oil. 1. Attach suction and discharge hoses. DANGER CARBON MONOXIDE: USING A GENERATOR INDOORS CAN KILL YOU IN MINUTES! 2. -
Page 10: Maintenance Schedule
MAINTENANCE SCHEDULE The following maintenance schedule should be followed to ensure proper performance of the unit. ITEM DAILY HRS. HRS. HRS. HRS. Visual walk around inspection Check engine oil level Check air filter Check external hardware Inspect hoses and housing for leaks Change engine oil Clean air filter Check and adjust spark plug... -
Page 11: Adding Engine Oil
ADDING ENGINE OIL 1. Place the pump on a firm, level surface. 2. Remove the oil fill cap/dipstick. Clean the area UPPER around the oil fill cap and wipe the dipstick clean. LIMIT 3. Insert the dipstick in oil filler neck. Do not thread into filler neck. -
Page 12: Unit Assembly And Parts
UNIT ASSEMBLY AND PARTS... - Page 13 ITEM PART DESCRIPTION NOTES 41852 Spring washer 41844 Suction flange 41843 Check valve 41849 Cap plug 41851 O-ring, 24mm 41840 Casing 41846 Packing 41845 Delivery flange 41841 Packing, U-type 41839 Inner casing 41837 Impeller 41838 Mechanical seal 41842 O-ring, 195mm 41836 Casing cover 41853...
-
Page 14: Unit Decals
UNIT DECALS WARNING ADVERTENCIA AVERTISSEMENT WARNING ADVERTENCIA AVERTISSEMENT MDP 200 PN: 26562 PN: 41945 Decal, small "M" - portables Decal, MDP200 PRIME PUMP BEFORE STARTING. Bomba primera antes de comenzar. Pompe principale avant de commencer. WARNING WARNING ADVERTENCIA ADVERTENCIA AVERTISSEMENT AVERTISSEMENT... -
Page 15: Notes
NOTES __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________... - Page 16 REV: A PART NO: 41860 05.27.09...