Assembling Instructions; Maintenance - Hyundai H-SF16-F1601 Instruction Manual

figures XX is the month of production, and following four figures XXXX is
the year of production.

ASSEMBLING INSTRUCTIONS:


The device is intended for air circulation in the room.

Fan is packed disassembled. Before assembling make sure that all the
required parts are undamaged and included into the set.

Do not plug in the device before its assembling is finished.

Tighten stand tube to stand base with screw. Fix base cover to stand base
with a screw (supplied with a set).

Unscrew out-joint, put the stand cover and base cover on the stand base,
pull the extension pole out then tighten the out-joint again.

Place control box firmly on top of extension pole, tighten screw B.

Unscrew the blade cap by turning clockwise and rear grill nut by turning
counter clockwise and put both blade cap and rear grill nut off the motor
shaft.

Put rear grille on motor shaft.

Secure it with rear grille nut.

Slide blades on motor shaft so that claws on motor shaft match the blades
slots.

Screw blade cap on shaft by turning counter clockwise.

Put front grille on rear grille and close clips or screw grille ring to secure
grilles together.

Adjust the fan vertically by vertical adjustment screw.

The fan is ready for work.
OPERATION MANUAL

CAUTION: To avoid electroconvulsive shock or fire danger, do not operate
fan under the conditions of increased humidity.

Place fan only onto dry flat unyielding surface.

The fan can work in three speed modes:
- "1" For minimum operational speed;
- "2" For medium operational speed;
- "3" For maximum operational speed;
- "0" The fan is switched off;
- "L" Night light mode.

On the upper part of the motor cover there is oscillating knob. If pressed, it
makes the fan cabinet with blades traverse from side to side. To cancel
oscillating mode push oscillating knob upward.

To switch the fan off push the button "0"

MAINTENANCE


Before cleaning unplug fan first.

Clean front and rear grilles, blades, stand tube and stand base with soft
moistened cloth and wipe dry.

Do not use abrasive cleansers
STORAGE

Keep the device in normal conditions in dry place.
7