Assembling Instructions - Hyundai H-SF16-F1602 Instruction Manual


Do not operate without fan installed protective grid.

Ensure that the fan is switched off from the supply mains before removing
the guard.

Do not attempt to repair, adjust or replace parts in the appliance. Repair
the malfunctioning appliance in the nearest service center.
 If the product has been exposed to temperatures below 0ºC for some time
it should be kept at room temperature for at least 2 hours before turning it
on.

The manufacturer reserves the right to introduce minor changes into the
product design without prior notice, unless such changes influence
significantly the product safety, performance, and functions.

Manufacturing date is indicated on the unit and/or on packing as well as in
accompanying documents in the following format XX.XXXX where first two
figures XX is the month of production, and following four figures XXXX is
the year of production.

ASSEMBLING INSTRUCTIONS:


The device is intended for air circulation in the room.

Fan is packed disassembled. Before assembling make sure that all the
required parts are undamaged and included into the set.

Do not plug in the device before its assembling is finished.

Tighten stand tube to stand base with screw. Fix base cover to stand base
with a screw (supplied with a set).

Unscrew out-joint, put the stand cover and base cover on the stand base,
pull the extension pole out then tighten the out-joint again.

Place control box firmly on top of extension pole, tighten screw B.

Unscrew the blade cap by turning clockwise and rear grill nut by turning
counter clockwise and put both blade cap and rear grill nut off the motor
shaft.

Put rear grille on motor shaft.

Secure it with rear grille nut.

Slide blades on motor shaft so that claws on motor shaft match the blades
slots.

Screw blade cap on shaft by turning counter clockwise.

Put front grille on rear grille and close clips or screw grille ring to secure
grilles together.

Adjust the fan vertically by vertical adjustment screw.

The fan is ready for work.
OPERATION MANUAL

CAUTION: To avoid electroconvulsive shock or fire danger, do not operate
fan under the conditions of increased humidity.

Place fan only onto dry flat unyielding surface.

The fan can work in three speed modes:
- "1" For minimum operational speed;
- "2" For medium operational speed;
- "3" For maximum operational speed;
7