Assembling Instructions - Hyundai H-SF16-RC03 Instruction Manual


Ensure that the fan is switched off from the supply mains before
removing the guard.

Do not attempt to repair, adjust or replace parts in the appliance. Repair
the malfunctioning appliance in the nearest service center.
If the product has been exposed to temperatures below 0ºC for some

time it should be kept at room temperature for at least 2 hours before
turning it on.

The manufacturer reserves the right to introduce minor changes into the
product design without prior notice, unless such changes influence
significantly the product safety, performance, and functions.

Manufacturing date is indicated on the unit and/or on packing as well as
in accompanying documents in the following format XX.XXXX where
first two figures XX is the month of production, and following four figures
XXXX is the year of production.

ASSEMBLING INSTRUCTIONS:


The device is intended for air circulation in the room.

Fan is packed disassembled. Before assembling make sure that all the
required parts are undamaged and included into the set.

Do not plug in the device before its assembling is finished.

Tighten stand tube to stand base.

Unscrew out-joint, put the stand cover and base cover on the stand
base, pull the extension pole out then tighten the out-joint again.

Place control box firmly on top of extension pole, tighten screw B.

Unscrew the blade cap by turning clockwise and rear grill nut by turning
counter clockwise and put both blade cap and rear grill nut off the motor
shaft.

Put rear grille on motor shaft.

Secure it with rear grille nut.

Slide blades on motor shaft so that claws on motor shaft match the
blades slots.

Screw blade cap on shaft by turning counter clockwise.

Put front grille on rear grille and close clips or screw grille ring to secure
grilles together.

Adjust the fan vertically by vertical adjustment screw.

The fan is ready for work.
OPERATION MANUAL

Place fan only onto dry flat unyielding surface.
BUTTONS

ON/SPEED - button switches the fan on and shifts between different
speeds. Press button 1 for a low speed, 2 for a medium speed and 3 for
a high speed.

OFF - turning off the fan
9