Panasonic KX-TG1100 Operating Instructions Manual page 7

Battery charge
Place the handset on the base unit or
charger for about 7 hours before initial
use.
Battery strength
Battery icon Battery strength
Fully charged.
054
High
5
Medium
6
Low
7
Needs to be charged.
074
Panasonic Ni-MH battery performance
Operation
In continuous use
In continuous standby
mode
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Operating time
10 hours max.
120 hours max.
Controls
Handset
A
B
C
D
E
F
G
H
I
A Receiver
B Display
C {k} (Phonebook)
D {C} (Talk)
E Navigator ({e}/{v}/{>}/{<})
F {R} (Redial/Pause)
G {R} (Recall)
H Charge contacts
I Microphone
J {j/OK} (Menu/OK)
K {ih} (Off/Power)
L {C} (Clear)
M {INT} (Intercom)
N Ringer
Base unit
LI NE
A Charge contacts
B {x} (Page)
Preparation
N
J
K
L
C
M
H
A
B
7