Connections - HP Pavilion S70 User Manual

Connections

Your monitor has two connecting cables: a Power
Supply Cord, which connects to a wall outlet, surge
protector or other power source, and a Signal Cable,
which connects to the graphics adapter of your
computer. To ensure safety and correct operation,
always follow these four steps when connecting the
monitor:
1
Make sure the monitor and computer are turned
off. (See previous section on safety.)
2
Connect the power cord to the back of the
display.
3
Plug the other end of the cable into a grounded
outlet.
4
Connect the video cable on the monitor to the
15-pin video graphics connector on the rear
panel of the computer, and tighten the fastening
screws.
12
S70 Monitor Guide
Filename: S70naug.doc Title: S70 Monitor
Template: HP-Print.dot Author: WASSER, Inc.
Revision #: 6 Page: 12 of 28 Printed: 05/13/99 11:33 AM
(If you have an HP Pavilion computer, this port
is marked in orange. For other computers,
check your computer manual for the video
port location.)
Note:
Last Saved By: WASSER, Inc.
Don't force the cable into the connector; line it
up carefully so you don't bend the pins.