Federal Communications Commission Notice; Canadian Notice - HP Pavilion S70 User Manual

Federal Communications Commission Notice

This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio or television
technician for help.
20
S70 Monitor Guide
Filename: S70naug.doc Title: S70 Monitor
Template: HP-Print.dot Author: WASSER, Inc.
Revision #: 6 Page: 20 of 28 Printed: 05/13/99 11:33 AM
X-Ray Radiation Notice
When operating, this product emits X-rays; however, it is well
shielded and meets the safety and health requirements of
various countries, such as the Radiation Act of Germany
and the Radiation Control for Health and Safety Act of the
United States.
Radiation emitted by this product is less than 0.1mR/hr
(1PSv/hr) at a distance of 10 centimeters from the surface of
the cathode-ray tube. The x-ray radiation primarily depends
on the characteristics of the cathode-ray tube and its associated
low-voltage and high-voltage circuitry. Internal controls
have been adjusted to ensure safe operation. Only qualified
personnel should perform any internal adjustments, as
specified in the service manual for this product.
Replace the cathode-ray tube with an identical CRT only.
Cables
Connections to this device must be made with shielded cables
with metallic REI/EMI connector hoods to maintain compliance
with FCC Rules and Regulations.

Canadian Notice

This Class B digital apparatus meets all requirements of the
Canadian Interference — Causing Equipment Regulations.
Last Saved By: WASSER, Inc.