Skil PWRCORE 20 RS5884-00 Owner's Manual page 12

To Attach/Detach Battery Pack
Lock the variable-speed trigger switch "OFF"
on the tool by depressing the lock-off button at
the side marked with icon
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves on the tool, and then slide the battery
pack onto the tool (Fig. 3).
To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool (Fig. 3).
NOTICE: When placing the battery pack on
the tool, be sure that the raised rib on the battery pack aligns with the groove in the tool and
that the latches snap into place properly. Improper attachment of the battery pack can cause
damage to internal components.
WARNING
when the tool is not in use or carrying at your side.
Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the
variable-speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure (Fig. 4).
12
.
Battery tools are always in operating condition. Therefore, the lock-
off button should always be depressed and in the locked position
Fig. 3
Attach
Fig. 4
Variable-speed
Trigger Switch
Battery-Release
Button
Detach