Table of Contents
Advertisement
Quick Links
I N S T A L L A T I O N I N S T R U C T I O N S
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Medium Flat Panel Steel Stud Wall Mount
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
JWDSK Series
Advertisement
Table of Contents
Related Manuals for CHIEF JWDSK
Summary of Contents for CHIEF JWDSK
- Page 1 Instrucciones de instalación Installationsanleitung Instruções de Instalação Medium Flat Panel Steel Stud Wall Mount Istruzioni di installazione Installatie-instructies Instructions d´installation Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description JWDSK Series...
-
Page 2: Installation Instructions
JWDSK Series DISCLAIMER Milestone AV Technologies, Inc., and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. - Page 3 TOOLS REQUIRED FOR INSTALLATION AND PARTS 1/2" (Ø13mm) Interface Bracket (Including Hardware) A (1) C (4) 8-32 x 3/8" B (2) D (4) (1/4"-20 x 1-3/4") (1/4"-20 SNAP TOGGLE BB) G (1) 3/16" JWDSK Series (3/16") (5/32") E (4) (1/4") F (4)
-
Page 4: Site Requirements
JWDSK Series Site Requirements IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY WARNING: OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum requirements for installation of display mounts onto a steel stud structure. If the structure or its components do not meet these requirements contact the mount manufacturer for specific instructions before attempting installation. -
Page 5: Mount Installation
SIDE VIEW Figure 4 Snap off plastic straps on anchor at wall by pushing side to side, snapping off straps level with flange of plastic cap. (See Figure 5) 10. Repeat steps 6 through 9 for each mounting hole. JWDSK Series... -
Page 6: Display Installation
JWDSK Series Steel Stud Drywall Plastic Cap Plastic Straps Anchor Metal Channel SIDE VIEW Figure 5 11. Place mount over anchors and align mounting holes in display mount with holes in anchors. (See Figure 6) 12. Place flat washer (E) onto Phillips pan head screws (D). -
Page 7: Cable Management
Swing Arm PIVOT / SWING Using 3/16" hex key (G), slightly loosen or tighten the adjustment screw(s) as necessary. (See Figure 10) Adjustment Screws JWDSK Series Ensure that adequate cable slack exists for Cable Path (typical) (B) x 2 (C) x 4... - Page 8 JWDSK Series Adjust display Roll, Pitch, and YAW tension Disconnect all wires and cable from the display. Remove two Lower screws securing display to Centris cup. Loosen two Upper screws securing display. Lift display upward and away from mount. Using a hex head wrench turn the tension adjustment screw clockwise to increase tension, or counter-clockwise to decrease tension.
- Page 9 Installation Instructions JWDSK Series...
- Page 10 JWDSK Series Installation Instructions...
- Page 11 Installation Instructions JWDSK Series...
- Page 12 JWDSK Series Chief Manufacturing, a division of Milestone AV Technologies, Inc. 8832-000220 RevC ©2008 Milestone AV Technologies www.chiefmfg.com 06/08 A 8401 Eagle Creek Parkway, Savage, MN 55378 USA/International P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands...
Need help?
Do you have a question about the JWDSK and is the answer not in the manual?
Questions and answers