LG RH16U8 VCW Series Owner's Manual page 14

INSTALLATION
14
WARNING
• Place the washing machine on a solid, stable,
level floor capable of supporting the weight of
both appliances.
• Do not stack the washing machine on top of the
dryer.
• If appliances are already installed, disconnect
them from all power, or water and from draining
connections.
This stacking kit includes:
• Two (2) side rails
• One (1) front rail
• Four (4) screws
To ensure safe and secure installation, please
observe the following instructions.
1
Make sure the surface of the washing machine
is clean and dry. Remove paper backing from
the tape on one of the stacking kit side
brackets.
2
Fit the side bracket to the side of the washing
machine top as shown. Firmly press the
adhesive area of the bracket to the washing
machine surface. Secure the side bracket to the
washing machine with a screw on the back side
of the bracket. Repeat steps 1 and 2 to attach
the other side bracket.
3
Place the appliance on top of the washing
machine, fitting the dryer feet into the side
brackets as illustrated. Avoid finger injuries; do
not allow fingers to be pinched between the
washing machine and appliance. Slowly slide
the appliance toward the back of the washing
machine until the side bracket stoppers catch
the dryer feet.
4
Insert the front rail between the bottom of the
appliance and the top of the washing machine.
Push the front rail toward the back of the
washing machine until it comes in contact with
the side rail stoppers. Install the two remaining
screws to secure the front rail to the side rails.