Fitting And Removal Of Base : Prolite Pb1705S - Iiyama ProLite PB1705S-1 User Manual

FITTING AND REMOVAL OF BASE : ProLite PB1705S


Put the monitor on a stable surface. The monitor may cause injury or damage if it
CAUTION
falls or is dropped.

Do not give a strong impact to the monitor. It may cause damage.

Unplug the monitor before removal or installation to avoid electric shock or damage.
<Installation>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor fl at on a table with front face down.
Install the Stand-Base to the Monitor.
<Removal>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor fl at on a table with front face down.
Press and hold the hooks inside, and pull the Stand-Base.
<Stopper pin>
Please stand the monitor and then remove the stopper
pin on the back of the stand slowly while pushing top
face of the stand before you install the monitor. Careful
attention is required as the monitor is sprung loaded and
may expand quickly when removing it.
Stand-Base
Hooks
BEFORE YOU OPERATE THE MONITOR
‑TOP‑
Stopper pin
6