Rear Terminal - Eiki XL Series Owner's Manual

①
① INFRARED REMOTE RECEIVER (Back)
The infrared remote receiver is also located in
the front and top. (pp.10, 15)
② LAN CONNECTION TERMINAL
Connect the LAN cable (see the owner's manual
of "Network Set-up and Operation").
③ ANALOG OUT TERMINAL
This terminal can be used to output the
incoming analog RGB signal from INPUT 1-3
terminal to the other monitor. (pp.19-20)
④ ANALOG (COMPUTER INPUT TERMINAL)
Connect the computer (or RGB scart) output
signal to this terminal. (pp.19-20)
⑤ AUDIO OUTPUT JACK (VARIABLE)
This jack outputs the audio signal from
computer, video, HDMI equipment to external
audio equipment. (p.21)
Never plug headphones and earphones into
AUDIO OUT jack.
⑥ R/C JACK
When using the wired remote control, connect
the wired remote control to this jack with a
remote control cable (supplied). (p.15)
⑦ HDMI TERMINAL
Connect the HDMI signal (including sound
signal) from video equipment or the DVI signal
from computer to this terminal. (pp.19, 20)
is registered trademarks of HDMI Licensing, LLC.
⑧ DIGITAL (DVI-D) TERMINAL
Connect the computer output digital signal to
this terminal. The HDTV (HDCP compatible)
signal can also be connected. (pp.19-20)
 Kensington Security Slot
This slot is for a Kensington lock used to deter
theft of the projector.
*Kensington is a registered trademark of ACCO
Brands Corporation.

Rear Terminal

④
② ③
⑨ ⑪
⑩
Part Names and Functions
⑤
⑥ ⑦
⑫ ⑬ ⑭ ⑮
⑨ 5 BNC INPUT JACKS
Connect the component or composite
video output signal from video equipment
to VIDEO/Y, and Pr/Cr.jacks or connect the
computer output signal(5 BNC Type [Green,
Blue, Red, Horiz. Sync, and Vert. Sync.]) to
G, B, R, H/V, and V jacks. (pp.19-20)
⑩ S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from
video equipment to this jack. (p.20)
⑪ VIDEO INPUT JACK
Connect the component or the composite
video output signal from video equipment
to these jacks. (p.20)
⑫ AUDIO 3 JACKS (L(MONO)/R)
Connect the audio output signal from video
equipment connected to ⑩ or ⑪ to this
jack. For a mono audio signal (a single
audio jack), connect it to the L (MONO)
jack. (p.21)
⑬ AUDIO 1 JACK
Connect the audio output (stereo) signal
from a computer connected to INPUT 1
terminals. (p.21)
⑭ AUDIO 2 JACK
Connect the audio output (stereo) signal
from 5 BNC INPUT jacks (INPUT 2 jacks).
(p.21)
⑮ CONTROL PORT CONNECTOR
When controlling the projector with RS-232C,
connect the control equipment to this
connector with the serial control cable. (p.19)
⑯ USB CONNECTOR (Series B)
Use this connector when controlling a
computer with the remote control of the
projector. Connect the USB terminal of
your computer to this connector with a USB
cable. (p.19)
⑧
⑯

11