Yamaha TT-R230A Owner's Manual page 64

MOTORCYCLE CARE AND STORAGE
Test the product on a small hid-
den part of the windshield to
make sure that it does not leave
any marks. If the windshield is
scratched, use a quality plastic
polishing compound
washing.
After normal use
Remove dirt with warm water, a mild
detergent, and a soft, clean sponge,
and then rinse thoroughly with clean
water. Use a toothbrush or bottlebrush
for hard-to-reach areas. Stubborn dirt
and insects will come off more easily if
the area is covered with a wet cloth for
a few minutes before cleaning.
After riding in the rain or near the sea
Since sea salt is extremely corrosive,
carry out the following steps after each
8 ride in the rain or near the sea.
1. Clean the motorcycle with cold wa-
ter and a mild detergent, after the
engine has
NOTICE: Do not use warm water
since it increases the corrosive
action of the salt.
2. Apply a corrosion protection spray
on all metal, including chrome- and
nickel-plated, surfaces to prevent
corrosion.
after After cleaning
1. Dry the motorcycle with a chamois
or an absorbing cloth.
2. Immediately dry the drive chain
and lubricate it to prevent it from
rusting.
3. Use a chrome polish to shine
chrome, aluminum and stainless-
steel parts, including the exhaust
system.
4. To prevent corrosion, it is recom-
mended to apply a corrosion pro-
tection
including chrome- and nickel-plat-
ed, surfaces.
5. Use spray oil as a universal clean-
er to remove any remaining dirt.
6. Touch up minor paint damage
cooled down.
caused by stones, etc.
7. Wax all painted surfaces.
8. Let the motorcycle dry completely
[ECA10791]
before storing or covering it.
spray on all metal,
8-2
WARNING
Contaminants on the brakes or tires
can cause loss of control.
G
Make sure that there is no oil or
wax on the brakes or tires.
G If necessary, clean the brake
discs and brake linings with a
regular brake disc cleaner or ac-
etone, and wash the tires with
warm water and a mild deter-
gent. Before riding at higher
speeds, test the motorcycle's
braking performance and cor-
nering behavior.
NOTICE
G
Apply spray oil and wax spar-
ingly and make sure to wipe off
any excess.
G Never apply oil or wax to any
rubber and plastic parts, but
treat them with a suitable care
product.
G
Avoid using abrasive polishing
compounds as they will wear
away the paint.
EWA11131
ECA10800