Yamaha XT250W Owner's Manual page 68

PERIODIC MAINTENANCE AND MINOR REPAIR
3. Remove the speedometer cable
holder by removing the screw.
4. Disconnect the speedometer ca-
ble from the front wheel.
1 5. Remove the axle nut.
2
2
1
3
4
5
1. Brake disc cover
6
2. Screw
3. Speedometer cable holder
4. Speedometer cable
7
5. Axle nut
6. Lift the front wheel off the ground
8
according to the procedure on
page 6-32.
9
7. Pull the wheel axle out, and then
remove the wheel.
CAUTION:
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
To install the front wheel
1. Install the speedometer gear unit
3
into the wheel hub so that the pro-
4
jections mesh with the slots.
5
1. Speedometer gear unit
2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
ECA11070
the speedometer gear unit fits over the
retainer on the fork leg.
EAU25011
1. Retainer
1
6-33
1
3. Insert the wheel axle, and then in-
stall the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
85 Nm (8.5 m·kgf, 62 ft·lbf)
6. Connect the speedometer cable,
and then install the speedometer
cable holder by installing the
screw.
7. Install the brake disc cover by in-
stalling the screws.
8. Install the engine guard by install-