Yamaha XT250T Owner's Manual page 44

PERIODIC MAINTENANCE AND MINOR REPAIR
6. Remove the oil filter element drain
bolt to drain the oil from the oil filter
element.
1
2
3
4
1. Engine oil drain bolt
5
2. O-ring
3. Compression spring
6
4. Oil strainer
7. Remove the oil filter element cover
7
by removing the bolts.
8
9
4 3 2 1
1. Oil filter element drain bolt
2. Oil filter element cover
1
3. Bolt
8. Remove the oil filter element and
O-rings.
1. Oil filter element
2. O-ring
9. Check the O-rings for damage and
3
(×2)
2
1
1
2
(×2)
6-9
replace them if necessary.
10. Clean the oil filter element with sol-
vent, and then install it.
NOTE:
Check the oil filter element for damage
and replace it if necessary.
11. Install the oil filter element cover by
installing the bolts and drain bolt,
then tightening them to the speci-
fied torques.
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
NOTE:
Make sure that the O-ring is properly
seated.
12. Install the engine oil strainer, com-
pression spring, O-ring and engine
oil drain bolt, and then tighten the
drain bolt to the specified torque.
CAUTION:
Before installing the engine oil drain
ECA10420