STATESMAN BU60LF Manual For Installation, Use And Maintenance

STATESMAN BU60LF Manual For Installation, Use And Maintenance

Built-under fridge

Advertisement

Quick Links

BU60LF
Built-under Fridge
Manual for Installation , Use and Maintenance

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BU60LF and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for STATESMAN BU60LF

  • Page 1 BU60LF Built-under Fridge Manual for Installation , Use and Maintenance...
  • Page 2: Before First Use

    Before first use You must allow the fridge to settle for at least twenty four hours prior to switching the power on. It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly drying the interior.
  • Page 3: Care And Cleaning

    Care and cleaning Always disconnect the appliance from the power before any cleaning or maintenance. • The refrigerator section should be cleaned using a solution of bicarbonate of soda and lukewarm water. • Do not use abrasive products or detergents. After washing, rinse and dry thoroughly. •...
  • Page 4: Troubleshooting

    Troubleshooting If you have any problems with your appliance, you should check the troubleshooting prior to calling Customer Care to prevent unnecessary service calls and potential cost. If the appliance is not working • Check there is power to the appliance: •...
  • Page 5: Installation

    Installation This appliance must never be installed close to heat sources i.e. heating elements, cookers or in damp places The appliance should be mounted on a piece of wood (for example a section of worktop or kitchen carcass) if a raised floor is to be fitted, if the kitchen floor is to be tiled after installation, or if the installation height of the appliance is greater than 850 mm.
  • Page 6: Reversing The Door

    Reversing the door It is possible to reverse the door on this appliance, if required. To do so, follow the steps below: • Loosen the hinge fixing screws (1). • Open the door. • Lever off the corner caps (3) with a knife blade. •...
  • Page 7 Installing the decor door • Screw mounting bracket (1) onto decor door using the screws supplied (as show in figure 4). • Fit the correct side towards the hinges. • Ensure there is a 5mm clearance between the underside of the worktop and upper edge (X) of the decor panel.
  • Page 8 Installing under a worktop • Adjust the feet to the required height. • Push the appliance into the niche until the decor door is flush with the adjacent furniture items, adjust the feet if necessary. • Pre-adjust the appliance at slots (4) as shown in figure 8, into the mounting plate on the worktop.
  • Page 9: Electrical Information

    Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2.

Table of Contents