ViewSonic ID2456 User Manual page 19

• VGA Connection
1. Connect a VGA cable from your computer to the VGA port on the monitor.
2. Connect the USB Type A to Type B cable from your computer to the monitor to
enable touch controls.
When using the touch function, please note:
• The touch function may need about five (5) seconds to resume if the USB
cable is removed and plugged in again, or the computer resumes from
Sleep Mode.
• The touchscreen can only detect up to ten (10) fingers simultaneously.
• If the Windows' cursor does not accurately follow your finger when you
touch the screen, do the following:
1. Open: Control Panel > Hardware and Sound >Tablet PC Settings
2. Select Calibration.
3. Follow the instructions to recalibrate your screen.
If Windows cannot identify the touch screen when you touch the screen, do the
following:
1. Open: Control Panel > Hardware and Sound > Tablet PC Settings
2. Select Setup.
3. Select Touch Input.
4. Follow the instructions to identify the touch screen.
HDMI
Type-C
HDMI
Out
VGA
USB 3.0
VGA
19
5V/2A