Webcam/Microphone Module - HP Pavilion DV6-1122 Maintenance And Service Manual

Webcam/microphone module

NOTE: This section applies only to computers equipped with BrightView display assemblies. See
Display assemblyon page 68
equipped with AntiGlare display assemblies.
NOTE: If it has been determined that the webcam/microphone module is the component that must be
replaced to complete the computer repair, the display assembly does not have to be removed. Follow
the procedures in this section to replace the webcam/microphone module. For information on replacing
the display assembly and other display assembly internal components, see
on page 68.
Description
Webcam/microphone module for use only with computers equipped with BrightView display
assemblies (includes cable)
Before removing the webcam/microphone module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Remove the webcam/microphone module:
1. Turn the computer display-side up, with the front toward you.
2. Open the computer as far as possible.
3. Flex the inside edges of the top edge (1) and the left and right upper corners (2) of the display bezel
until the bezel disengages from the display enclosure.
for webcam/microphone module removal instructions for computers
Battery on page 48).
Display assembly
Spare part number
512827-001
Component replacement procedures 49