HP Pavilion DV6-1122 Maintenance And Service Manual page 95

d. Display assembly (see
e. Top cover (see
f. USB board (see
g. System board (see
Remove the power connector cable:
1. Remove the power connector cable (1) from the clips and routing channel (2) built into the base
enclosure.
2. Remove the Phillips PM2.5×7.0 screw (3) that secures the power connector and bracket to the
base enclosure.
3. Remove the power connector bracket (4).
4. Remove the power connector cable assembly (5).
Reverse this procedure to install the power connector cable.
Display assembly on page
Top cover on page 80).
USB board on page 85).
System board on page
68).
88).
Component replacement procedures 87