Table of Contents
Advertisement
2.6
SIP Configuration Page
The SIP Configuration page allows an administrator to configure the respective SIP channels or
lines of the device. Lines/channels can be set for different modes of operation, turned on or off,
etc., depending on specific application needs. See Figure 6 below.
Figure 6
'On'– Allows the administrator to turn on / off the respective line or set channel to 'No PBX'. If
•
turned off, 'line information' will not be displayed on the device.
Channels 1-4 – This field allows the administrator to assign a name to the respective channel.
•
This name will be displayed on the device. It is recommended to use upper case letters and
limit number of characters to 4 per channel.
SIP Server – This field allows the administrator to input the address of the SIP Server to which
•
the device will register with. Can be either DNS name or IP address. Each channel can be
configured to register with a different SIP Server if desired.
SIP Server 2 – This field allows the administrator to input the IP address of a backup SIP server
•
in the event the primary is not available.
SIP User – This field allows the administrator to assign an extension or SIP identifier for
•
registration.
SIP Password – This field allows the administrator to assign the SIP Password for registration.
•
Reg/Fail Timeout – These fields allows the administrator to set the time span, in seconds, for
•
re-registration and registration fail of the channel to the SIP server.
Number to Dial – This field allows the administrator to assign an extension the device will dial.
•
Note: This function works in conjunction with specific 'Mode' selected.
RTCP Timeout – This field allows the administrator to set the time span, in seconds, in which
•
the device will drop an active call after RTCP packets are no longer present.
Auto Answer – If checked this option sets the device to automatically answer an incoming call
•
to the respective channel as assigned in the SIP User field.
available with specific 'modes.'
Listen Only – Allows administrator to set a specific channel for listen only mode.
•
CS-74 Administration and Set Up Guide
Page 10
This option only becomes
Essential Trading Systems Corp.
Advertisement
Table of Contents
