ETC CS-74S Administration & Setup Manual page 12

Channel Reload – The CS-74 also has a feature which allows an administrator to change a
•
single channel and load the new configuration for the channel without affecting the connection
status of the other channels. By clicking the reload device button at the bottom of the screen
the administrator is presented with options to reload specific channels or all channels. Once a
channel configuration has been changed you must save new configuration then select channel
to be reloaded for changes to take effect. See Figure 7a below.
Figure 7a
Call without PBX – The CS-74 has the capability to make/take calls without registration or
•
connection to a SIP PBX. This can be enabled on a per channel basis. Figure 7b below
shows a drop down to the left of each channel where an administrator can select to turn the
channel off, turn it on or select No PBX to set channel for no registration. No PBX allows the
CS-74 to make/take direct point to point calls from another device or gateway without a PBX.
In this mode the CS-74 will not send registration requests.
Figure 7b
CS-74 Administration and Set Up Guide Page 12 Essential Trading Systems Corp.