Networking Page - ETC CS-74S Administration & Setup Manual

2.5

Networking Page

The Network Settings page allows the administrator to configure the device with a static IP
address or configure using DHCP. Device is default DHCP and IP address will be indicated on the
display during boot up. See Figure 5 below.
Figure 5
IP Address – Enter static IP address for the gateway. In DHCP mode, device will default to
•
192.168.0.240 in the event it cannot retrieve an address from a DHCP Server.
Subnet Mask – Enter the Subnet Mask for the gateway.
•
Default Gateway – Enter the Default Gateway for the gateway.
•
NTP Server – Enter IP or DNS name of NTP (Network Time Protocol) Server. If left blank
•
device will not poll for time/date.
DNS Server 1 – Enter the IP address of the primary DNS server if DNS will be utilized.
•
DNS Server 2 – Enter the IP address of the secondary DNS server if DNS will be utilized.
•
STUN Server – Enter IP address of STUN Server. Needed for firewall penetration.
•
DSCP/QoS – Click drop down to select Default Forwarding or Expedite Forwarding. Expedite
•
Forwarding tags RTP packets with DSCP bits 46 (EF). Default Forwarding does not tag RTP
packets. CS-74's are shipped factory set to Default Forwarding.
When finished entering IP information click the Save Configuration & Reload button at bottom of
screen. Once finished with the reload, click the Reboot button.
Rebooting is required after making device IP address changes.
CS-74 Administration and Set Up Guide Page 9 Essential Trading Systems Corp.