Table of Contents
Advertisement
2.8
Management page
The Management tab currently provides an administrator access to input Syslog Settings for
reporting device status, device type selection & browsing settings. Additional features will be
added to this page as necessary. See figure 9 below.
Figure 9
Syslog Active – Click the check box to enable Syslog reporting feature, uncheck to disable.
•
Syslog Server – Input the respective IP address of the Syslog server where status reports will
•
be sent.
Syslog Server Port – Input the respective port the device will be reporting status to.
•
Syslog Facility – Click the arrow for a drop down menu to select reporting ID. Selecting one of
•
the displayed selections will cause the device to report activity with this 'ID' which can be used
for filtering and/or sorting messages from specific devices.
Severity Level - Click the arrow for a drop down menu to select reporting priority.
•
o Verbose – All messages are reported
o Critical – Only messages classified 'critical' will be reported.
Device Type - This drop down allows an administrator to change the device type from a SIP
•
device (CS-74) to a multicast device (CS-64). To change device type, click the drop down,
select the device type (SIP or Multicast) then click the Set Device Type button to activate the
change.
WARNING!
Please refresh (shift F5) your browser window immediately after changing the device type to
avoid configuration data loss.
Enable HTTP – Unchecking this option allows only secure (https) browsing to device for
•
configuration. Device is shipped default to 'Enable.'
Note: Syslog message definitions are provided in appendix 4.2 of this guide.
CS-74 Administration and Set Up Guide
Page 15
Essential Trading Systems Corp.
Advertisement
Table of Contents
