System Board - HP Pavilion DV5-2129 Maintenance And Service Manual

Remove the power connector cable:
1. Disconnect the power cable (1) from the system board.
2. Remove the power connector (2) from the alignment clip built into the base enclosure.
3. Remove the power connector cable
Reverse this procedure to install the USB board.

System board

NOTE: The system board spare part kit includes replacement thermal material.
Description
For use on computer models equipped with an AMD processor (includes graphics subsystem with
UMA memory)
For use on computer models equipped with an Intel processor (includes graphics subsystem with
discrete memory)
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Memory module/wireless module compartment cover (see
b. Hard drive (see
76 Chapter 4 Removal and replacement procedures
Battery on page 49), and then remove the following components:
Hard drive on page 58)
Spare part number
598225-001
607605-001
Memory module on page 50)